●When RCP-300 was regarded as an imaging device.

When RCP-300 contact with personal computer at first, in case of RCP-300 is set for [ Printer Mode ].It was regarded as an imaging device on the Windows.
So USB driver do not install in formal.
In this  case, We explain  the installation procedure of USB driver.
  1. [ PictBridge Test Model. ]dialogue is displayed.
    Click [Cancel] button.

  2. Please change to [ TAM Mode ] from [Printer Mode] on RCP-300 mode.

    RCP-300 display

    		 Operation Panel.
    Connecting
    Printer     		Click [Cancel] button, back to the start display.
    2007/xx/xx 09:30
    Printer Mode     		Click [Menu] button.
    Menu Selection
    1.Clock Setting     		Click [+] button.
    Menu Selection
    　 4.Settings     		Until 4.Settings be display, Click [+] button
    and Click [Set] button.
    RCP-300 Settings
    1.Menu Wait     		Click [+] button
    RCP-300 Settings
    2.Set Comm Menu     		Click [Set]button.
    Set Comm Menu
    Printer TAM     		Select TAM by [+] or [-] button, Click [Set] button.

    * Select item is flashing light.

    RCP-300 Settings
    2.Set Comm Menu     		Click [Menu] button.
    Save Settings
    Don't power off!     		Message is displayed.
    Wait for seconds, until set be stock.
    Menu Selection
    4.Settings     		Click [Menu] button.
    2007/xx/xx 09:30
    TAM Mode     		Start screen is displayed.

  3. [ PictBridge Test Model. ]dialog box is displayed.
    Click [Cancel] button.

  4. Selected [my computer] from [START] menu with right side. When right click ,menu is appeared and selected [property].

  5. Select [Hardware] tab.Click [Device manager] button.

  6. Right click on [PictBridge Test Model.], Menu is displayed. Select the [Delete].

  7. [Device Delete Confirmation] message is displayed.
    Click the [OK] button.

  8. [New hardware Retrieval wizard start] is displayed.
    ○Initial USB driver installation procedure
    After refers, please install USB driver for RCP-300.